| MP-888 |
Microprocessor Temperature Controller |
| Features |
- Self-optimizing feature allows a very high regulating accuracy even at high temperatures
- Adheres to the set temperature independently of the consumer
- Can be adjusted to indicated °C or °F
- The analogue interfaces 0 - 5 V, 0 - 10 V and 4 - 20mA are standard included in the controller
|
| Operating Elements |
| Term |
Function |
| Set Value Indication |
Set temperature, required temperature |
| Actual Value Indication |
Actual temperature, measured, effective temperature |
| Flow Rate Indication |
Display in litres/min (British) or gallons/min (American) |
| Temperature Adjustment |
Raise / Reduce of set value |
| Programming |
Press 3 seconds (Program Steps 1 - 67) |
| Flow Control |
|
| Monitoring (LED Green) |
Flow control active |
| Alarm (LED Red) |
Alarm flow control |
| Cooling ON |
Lights up when the cooling relay is activated |
| Heating ON |
Lights up when the heating relay is activated |
| Sensor Failure |
Lights up when the sensor is not connected correctly or the wrong type of sensor is used |
| Temperature Deviation Control |
Lights up when the difference between set and actual temperature is too high. Factory set ± 5°C (± 9°C) |
| Maximum Temperature |
Lights up, when the maximum temperature has been reached. (Model Dependant) |
| External Temperature Control |
Lights up when the set point is adjusted from external by putting on current / voltage. |
Post Info: Home » Products » Machinery » Plastic & Rubber Machinery » Plastic Auxiliary Equipment » Mould Temperature Controller »
Click for original picture
